or make 4 interest-free payments of $9.00 AUD fortnightly with More info
We have created a new external transducer mount for the Stealth kayak range with the new molded handles to address the issue of total-scan and side scan transducers not being able to shoot thru-hull.
It comes in two parts in order to match your ski and sounder setup -
Part A is the top pivot with varying length to suit different Stealth models
Part B is the transducer arm that must be matched to your transducer type.
Select the correct transducer arm for your sounder type below, and couple with the correct top pivot to complete your setup.
The transducer arm attaches to the pivot using the supplied stainless bolt and the transducer will connect to the arm using the hardware that came with your sounder for their transom mount.
There are a couple of methods for routing your transducer cable into the fish hatch depending on the size of the transducer plugs on your unit. You can drill a small hole in the rear deck* to allow the transducer cable into the hull. The hole can be sealed with silicon and then covered with a cable clam, or transom cable cover. These come included in the box with some Garmin sounders or can purchased at most marine stores.
For sounders with large transducer plugs, a Hobie three way thru hull plug can be installed on the rear deck in front of the rudder access port. Unfolded wire coat hangers or an extended measuring tape, can then be used to run the cables into the hull along the side of fish hatch and out at the battery box.
*Note care should be taken when drilling holes in the rear deck so as not to cut the rudder lines.
This Kit Includes:
- Transducer arm
- cable tie
The transducer arm length has been configured to leave your transducer sitting just below the waterline for paddlers 90-110kg, if your weight sits well below this range we can supply and extra long dropper arm to compensate for the higher ride height of your ski.